KEYTEC large touch screen standard models

Home Company Products References Support Download Where to Buy Contact Us

Products > Large Size Touch Interactive Solution > Large Resistive Touch Screen Overlay > Mounting Frame

The aluminum mounting frame is designed for the standard large-size resistive touch screens. Custom sizes can also be made to match your custom large-size touch screen (minimum order requirement may apply). These are non-stock items and typical lead-time is about 4 weeks after receiving your confirmed order. However, we may have small quantities in stock from time to time, so do feel free to contact us to check the status if you have immediate need. Note: The frame adds 0.75" to each side of the large touch screen.

Mounting instructions for KEYTEC’S large-size add-on touch screens:

Note: It requires two people to do the mounting to avoid any accidental damages. Download PDF file.

There are two hangers. Attach them to top two corners. The cable is typically located at lower right corner unless otherwise specified by the customer.

Hang the touch screen up to the display. Use the screws on hangers to adjust the position of the touch screen to make sure its active area covers the display’s view area.

There are two pairs of Velcro straps for tightening the touch screen to the back of the display.

Screw in the short Velcro straps on top of the frame next to the hanger, and the long Velcro straps at the bottom of the frame.

Pull both Velcro straps to the back of the display.

Connect and tighten the Velcro straps at the back of the display.


After two vertical Velcro straps are tightened, use the long Velcro strap to pull these two vertical Velcro straps toward the center to make them tighter.